The lithographic version of the stencil network is missing, and it is false (2)
Third, there is a gap between the original and photosensitive version
1, lack of vacuum
Before the exposure, it is necessary to vacuum the printing machine's drying chamber so that the original plate and the photosensitive plate are closely attached together. If the vacuum is improperly set or if the vacuum pump malfunctions, the suction tube ages and breaks, and the weatherstrip sealant strip ages and cracks, vacuum insufficiency will occur. The original and sensitized plates will not cling together and cause dots to be lost and become imaginary.
2, there is dirt between the original and photosensitive version
Before the printing, the film should be cleaned. If the cleaning is not thorough, there will be small sand and other dirt on the film. After the printing plate is developed, dirt will appear, and the surrounding network of the dirty spots will also be lost. .
3, fight the original group
In many print editions for books and magazines, printers often output small format films for cost considerations, and then use hand-crafted imposition to make up large prints. When assembling large plates, the edges of small films may show “wavy edges†or “glitches†when they are cut. These phenomena will cause gaps between the original plate and the photosensitive plate to be used during the printing process. Loss of outlets and occurrence of virtual phenomenon.
In addition, due to the use of adhesive tape to fix the small film on the film base, if the tape is too close to the text or image area, it will also cause the loss of the network points, hair vomiting, or lack of writing.
4, even when the cover of the sun too close to the original
When printing, sometimes encounter the situation that requires the use of a four-open film or even an eight-open film to dry off the half-printing plate. In most small-scale printing factories, this kind of situation is often encountered by hand. The way to solve. In the case of using a four-shot film for printing, a two-part exposure is required. During each exposure, half of the sensitized plate needs to be covered. If the cover is too far from the original position, waste of paper will be caused during printing; however, if the cover is too close, it will cause the original plate to cling to the photosensitive plate in the process of pumping, so that the dots on the plate will appear. Lost and made false. Therefore, during the continuous drying, the size of the middle seam should be selected according to the size of the paper used for printing.
Fourth, other factors
1, the photosensitive or original crease
In the case of printing, both the original or the photographic plate do not cling closely to each other in a creased position. This can result in the loss of the dots and the appearance of ghosts during the printing process. Therefore, it is very important to carefully check the original and photographic plate before printing.
2, double exposure
The double exposure is a book edition, especially a method used to eliminate dirt from the layout, which is often used in the original printing of the group. This method of removing dirt is to use a scattering film to refract light so as to remove the dirty lines and dirt generated on the edges of the film. However, this method also causes the loss of small dots. Therefore, it is not appropriate to use the image printing plate for secondary printing. exposure.
3, over development
Excessive development will not only cause the loss of small outlets, but also reduce the printing rate of printing plates.
4, repair accidentally
At the time of revision, if the revision paste or the correction fluid were eroded to the graphic part, the loss of dots and hairlines would be inevitable. At the time of revision, the revised paste or revised liquid medicine is rinsed off in time to avoid damage to the layout.
Kitchen Equipment Co., Ltd. , http://www.dgtiande.com