Screen processor
The T800 Direct Platesetter is a powerful entry-level output device with exceptional image quality, reliability and consistency. Based on the highly successful Kodak Full Victory Platemaking Platform and Kodak's new TH5 thermal imaging technology, the T800 Direct Plates helps you provide high quality plates. This article will introduce you to the circulator circ.
Many users who use the T-series processor may encounter a failure when the button is turned on and any button on the touch screen is unresponsive. This failure will cause the processor to not enter the standby state normally. This fault is caused by the potential drift of the scanner's touch screen. If this happens, please follow the steps below to recalibrate the processor touch screen to troubleshoot.
Turn on the main power of the processor. If the processor has been turned on, please turn off the main power of the processor and turn it on again. After the shutdown, please wait 20 seconds - 20 seconds before turning on the main power of the processor.
After the screen correction is completed, the prompt message PressthegreenStartbutton will appear again on the screen. Now press the green start button next to the screen, the device starts normally, and the fault that the touch screen does not respond can be eliminated.
Whether there are any damage caused by transportation in all parts of the platen machine, if any, immediately make a corresponding record and take pictures of the damaged part, and contact the carrier or supplier in time. A 4-point tap water pipe should be connected to the equipment room. The height of the machine room drain should not be 150mm higher than the floor space of the platen machine. In order to facilitate the cleaning of the roller shaft and other parts, a properly sized pool should be provided in the equipment room.
Article source address: http://
Plastic Bottle,Plastic Bamboo Bottle,Plastic Sports Bottle,Plastic Bottle For Drinks
Ningbo Auland International Co.,Ltd. , https://www.eversportsbottle.com