How to install cloth closet installation cloth wardrobe
[ Chinese wardrobe network ] Friends who rent a house outside or friends who live in the company dormitory, many people will buy the assembled cloth wardrobe , this wardrobe needs to be installed by itself, in fact, the cloth wardrobe is very simple to install. The following small series will introduce you to the installation method of the cloth wardrobe. Let's take a look.
Cloth Wardrobe Installation - Check Packaging
First of all, when receiving the goods, whether it is express or direct purchase, be sure to check whether the packaging is seriously damaged. If there is, it is likely that the steel pipe inside is also crushed. Such goods must not be signed and purchased. Check it out clearly.
Cloth wardrobe installation - check accessories
Open the package, and then check whether the accessories inside are complete. There is a manual, check the instructions. If there are few, it is estimated that you can't install it without using it. Therefore, the number of advances is clear, so as not to be wasted. When installing, be sure to wear gloves. And must carefully read the instructions.
Cloth wardrobe installation - first installed bottom
First install the bottom one, take out the four-way joint with the bottom and the high, and connect with the short tube in the middle. Install a four-way joint on each side, then install the tube on both sides, decide the position of the place, and install the long tube. Short tube. Then install the base fabric on both sides, and then install a three-way joint around each other.
Cloth wardrobe installation - wardrobe cover
After installing the bottom, insert six short steel pipes, then put the whole wardrobe cloth up against the surrounding holes. Then install a layer of the bottom plate and then put it on the six steel pipes.
Cloth wardrobe installation - short floor
If the wardrobe is divided on two sides, first install the short-side floor, first insert the side steel pipe, then install the cloth, then connect the four-way joint, then install two horizontal steel pipes, then install the cloth, then Then make up the four-way joint on both sides. Repeat the baffle until it is attached to the top.
Cloth wardrobe installation - long steel pipe
After the short-side partition is installed, the long side is a vertical hanging area, and a three-way joint is used to connect the two long tubes to the top.
Cloth wardrobe installation - top steel pipe
After the two sides are installed, connect them directly with long steel pipes, so that the wardrobe is installed. If the wardrobe is too high and not enough to squeeze, it is recommended to push the side backwards so as not to be installed. At the same time, the hanging steel pipe can also be used. The connector is installed, this is relatively simple.
Cloth wardrobe installation - wardrobe cover
When the top of the big set is at the top, it is best to pull the bottom to the top, so that there is space to pull on the top until the corners are installed diagonally. At this time, the cloth cover can be pulled down. The wardrobe is installed. After that, I feel that the whole wardrobe is so big. It is more than a small series. It takes an hour to install it. As long as it is careful, it will not be wrong.
The above is for everyone to introduce the method of cloth wardrobe installation, but also to remind everyone that when installing, you should install the wide short tube first, then install the two sides, it is easier, friends who are ready to buy cloth wardrobe can Follow the steps above to install the cloth closet. Don't think it is too difficult.
Sofa Bed,Corner Sofa Bed,Sofa Bed Couch,Single Sofa Bed
Hebei siuno household supplies co.,ltd , https://www.ciaosleep.com